PG 6
www.summitstands.com
ASSEMBLY (SENTRY ONLY)
4
FRAME FOLDING (EXPLORER ONLY)
5
The Seat Back must be assembled on the Sentry Models before use.
1.
Insert (1) Short Shank Bushing on the OUTSIDE of the welded bracket on the Seat Platform.
See figure 1.
Insert another
Short Shank Bushing on the OUTSIDE of the welded bracket on the Seat Back.
See figure 2.
2.
Position the Seat Back between the two welded brackets on the Seat Platform as shown in
figure 3.
3.
Secure each side using (1) 3/4” bolt with lock nut. Do not overtighten as this connection is designed to pivot. The completed
seat back should look like
figure 4
.
Part Stack: Short Shank Bushing, Seat Platform Bracket, Short Shank Bushing, Seat Back Bracket, Locknut
The foot platform and seat on the Explorer line of treestands is designed to fold flat for packing. Before climbing both platforms
must be unfolded and the V-brace must be locked into place.
1.
Pivot the V-brace up and out and line it up with the slot.
See figure 5.
2.
Remove the safety pin. Pull the spring loaded latch pin toward the front of the Platform and press the V-Brace into the slot
until it completely bottoms out.
See figure 6 and figure 7.
1
2
3
4
5
6
SHORT SHANK
BUSHING
V-BRACE
LATCH PIN
V-BRACE FULLY
SEATED IN SLOT
