3
RESTARTING BURNER AFTER EXTENDED SHUT DOWN.
The complete oil burner should be checked and serviced by a qualified technician.
• Check oil pump strainer
• Replace oil filter cartridge
• Check electrodes
• Oil burner motor ( see lubrication section )
• Restart burner by following instructions in; “STARTING THE OIL BURNER” section.
• If your furnace has been shut off for an extended period – contact your qualified service technician
for start – up
SUMMER FAN OPERATION
During summer, continuous air circulation can be obtained by pulling / sliding the manual fan switch from
the “Auto” position to the “On” position
DUAL AIR OPERATION
This furnace is equipped with a dual ( two ) speed blower system which allows partial air distribution
at all times. When the thermostat calls for Heat, the Oil Burner starts and the HIGH speed quickly
distributes warm air throughout the home. When the HIGH SPEED stops, the “LOW” speed continues
operating, circulating the air to even the temperature throughout the house. If the “LOW” speed feature
is not required / desired, operate the small “rocker” switch located on the power junction box.
MAINTENANCE
OIL FURNACE ANNUAL SERVICE
The oil burner and furnace should be thoroughly cleaned and serviced annually by a qualified service
technician, and where required by law, a licensed technician.
The nozzle should be changed annually - handle nozzle with care so that the inside surface tip is not
scratched. The electrodes should be cleaned and adjusted (see oil burner manual with the oil burner).
LUBRICATION
Apply 2 – 3 drops of SAE 20 – 30 Non Detergent oil ONLY to the oil port(s) located at either end of the
burner motor.
Apply 2 – 3 drops of SAE 20 – 30 Non Detergent oil ONLY to the oil ports located at either end of the
blower motor.
DO NOT OIL THE FAN BEARINGS!
CAUTION :
Before cleaning, shut off electrical power supply to the furnace.
