9
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8AM to 5PM MST, Monday-Friday.
Extended operating days and hours during peak season requirements.
OWNER’S MANUAL
SETUP INSTRUCTIONS
6. Now the Pump should be installed outside the pool wall as below.
WARNING:
CLIMBING HAZARD! PLEASE PREVENT CHILDREN FROM CLIMBING ON THE FILTER CANISTER TO GAIN ACCESS TO THE POOL.
Before assembly, take a few minutes to identify and become familiar with all the parts.
Pool Inlet
Skimmer Opening
Inside Pool Wall
Inside Pool Wall
Outside Pool Wall
5
Inside Pool Wall
No gap here
Make sure that the pool liner is
placed tight on the Gasket
25
and is NOT trapped in the threads;
otherwise leaks may occur.
thread slots
Make sure the Hose Clamps
11
seals tightly over both the Return
Hose
12
and O-Rings
10
.
To optimize water circulation,
twist the RF Diverter
19
so
that it faces up and away
from the Skimmer Opening.
4. Insert the threaded part of the Skimmer Canister
9
through the Skimmer
Opening, and then secure with the Skimmer Seal Ring
22
.
The protruding edge of the
Skimmer Canister
9
fits
in-between the two keys of
the Gasket
25
.
3. Turn counterclockwise to remove the Skimmer Seal Ring
22
. Make sure
the Skimmer Gasket Rubber Seal
25
is in the correct position.
Skimmer Installation
1. Set up your pool following the pool Owner’s Manual instructions. Do NOT fill
water until the Filter Pump is properly installed. Locate the Skimmer Opening
on the pool wall.
2. Slide open the Top Cover
5
and take out the parts inside.
Return Fitting Installation
5. Assemble the Return Fitting
18
as indicated below.
