Tray One
User’s Manual
Setup
1-2
Do the same at the other side.
Slide the tray in the slots of the plates
Put the brackets over the threaded pins and
secure the with 4 washers and the smaller
grip knobs. Mind the orientation of the
washers (see detail)
Make sure the rear roll on the cutter is in its
most back position. Locate the 4 feet on the
cutter. They will fit in the feet holders that
just have screwed on the plates in step 2 of
this procedure.
Put the cutter on the plate make sure the feet
fit in the feet holders.
Summary of Contents for TRAY ONE
Page 1: ......
