S One
User’s Manual
Detailed operation
4-2
The advantage of the FlexCut feature is that it cuts completely through the media. In addition,
it ensures that the material stays together by means of small media bridges.
There are 5 typical FlexCut parameters:
1.
Full pressure:
This parameter determines the full pressure that is used in FlexCut mode.
2.
Full pressure cut length:
This parameter determines the length that is cut with full
pressure, usually the length that is cut all the way through.
3.
Flex pressure cut length
: This parameter determines the length that is cut with reduced
pressure or without pressure. This is usually a much smaller value than
Full pressure
cut length
–
this is the length of the media bridges.
4.
Flex pressure:
This parameter determines the pressure of
Flex pressure cut length
. This
is usually a reduced pressure so that the knife only scratches the media or only cuts it
only halfway through.
5.
FlexCut Velocity:
FlexCut uses higher knife pressures. Higher knife pressures require a
lower cutting speed. With this parameter, the velocity of FlexCut can be set
independently from the normal cutting velocity.
Two tools can be used on the S One: a knife or a pen. If the tool has been changed, use this
menu to set up the machine to use the newly inserted tool. This is explained in chapter 2.2.1.
4.2.5
Submenus
The rest of the menu items in the main menu are submenus and are explained in the sections
below.
4.2.3
FlexCut
4.2.4
Tool
Summary of Contents for S CLASS
Page 1: ...User Manual Rev 003 ...
Page 52: ......
