S One
User’s Manual
Detailed operation
4-6
FIG 4-5
4-5
CALIBRATIONS MENU
This calibration is used for particular combinations of registration mark colour and media
colour. The procedure is explained in section 3.4.2.
This calibration determines the distance between the centre of the OPOS sensor and the knife
tip. This is a media-independent calibration and may only be performed when the knife holder
has been removed. The procedure is explained in section 3.4.1.
The media sensor is calibrated in the factory and detects the end of most common media.
However, in a few rare cases, the sensor fails in doing so (e.g. media with a black backing or
transparent media). In this case, the sensor can be adjusted so that it detects correctly also
with such media.
FIG 4-6
4-6
BACK SENSOR FOR MEDIA DETECTION
NOTE:
Media sensor calibration is user dependent. If necessary, select a separate
user for a special media and calibrate the sensor. Then switch to that user when
that media is used again.
Length calibration
Calibrate OPOS
Length calibration
Media sensor setup
Calibrate OPOS
Calibrate media (OPOS)
Calibrations
4.5
Calibrations
4.5.1
Calibrate media (OPOS)
4.5.2
Calibrate OPOS
4.5.3
Media sensor setup
Summary of Contents for S CLASS
Page 1: ...User Manual Rev 003 ...
Page 52: ......