S One
User’s Manual
OPOS
3-5
For standard OPOS jobs, you only need to place the tool above the first mark to start the job.
OPOS allows you to automate certain jobs, thus reducing user intervention and production
time. There are different types of automation.
Automatic start of the OPOS job
This is controlled by the
OPOS origin
parameter. Thanks to the combination of this parameter
setting and/or a special origin setting during media loading, you do not need to place the tool
above the first mark to start an OPOS job.
Multiple copies of the same job
When cutting multiple graphics, you only need to place the OPOS sensor above the origin mark
of the first graphic. Cutting subsequent graphics requires no further action from you.
There are two multi-task situations in which OPOS can be used:
1.
When cutting multiple (copies of a) graphic(s) on the same media roll.
2.
When cutting the same graphic on multiple sheets.
Most automated jobs are organized from the cutting software. However, when the same
graphic contour has to be cut out, the automated job may also require some manual
manipulation.
Unattended contour cutting (roll to roll)
A special barcode can be printed with the job, which is then used to access the correct cutting
data, allowing the cutter to cut one job after another without user intervention.
3.3
Automating OPOS tasks
Summary of Contents for S CLASS
Page 1: ...User Manual Rev 003 ...
Page 52: ......
