16
INSTALLING AUGER PADDLES
1. Install spacers into paddle holes. (Figs. 24-26).
IMPORTANT:
Install new paddles so wear indicator holes are positioned on
the right side of unit.
INSPECTING THE AUGER PADDLE
1. Secure each paddle to side plates with four hex bolts, four flat steel washers
and four flange nuts.
2. Secure each paddle to centre plate with two hex bolts and two flange nuts.
3. Torque paddle hardware to 5.6 N m - 10.2 N m 50 lb per inch to 90 lb per
inch. DO NOT overtighten.
4. Rotate auger paddles by hand to ensure paddles are secure and do not
interfere with housing.
5. Return unit to upright position.
6. Remove slack from auger cable. See Adjusting Control Cable on page 14.
7. Reconnect spark plug wire and turn fuel valve to the on position.
DRIVE BELT
REMOVING THE DRIVE BELT
1. Stop engine and wait for all moving parts to stop and for hot parts to cool.
2. Disconnect spark plug wire.
3. Remove belt cover hardware and remove cover. Retain all parts (Fig. 27).
4. Disconnect extension spring from idler arm (Fig. 28).
5. Remove belt from drive sheave, idler sheave and engine sheave.