Page 5
Rev. 01-21-21
www.SullivansUSA.net
INSTRUCTIONS
2
THE BASE
Parts Needed: A/B-(2), C, D, E, F, G, H, I, #1-(14), #2-(4), #3-(4), #6-(5), #12-(18), #13-(27), #16-(8),
#18-(2), #20-(2), Phillips Screwdriver (not included)
2A
2B
Insert 6 Cam Locks (#13) into the holes on the top of the Left (D) and
Right (E) Panels with the arrow on the Cam Lock pointing up. Install
8 Cam Bolts (#12) into 8 pre-installed plastic holes on Left (D) and
Right (E) Panels with Screwdriver. Use 2 Screws (#2) and Screwdriver
to fasten 1 Magnet (#18) to Right Panel (E). The metal bars face in the
direction indicated by the arrow.
2C
Flip Right Panel (E) over.
Install 1 Magnet (#18) with 2 Screws (#2)
using a Screwdriver. The metal bars face in the direction indicated
by the arrow. Screw in 5 Cam Bolts (#12) into 5 pre-installed plastic
holes on Right Panel (E) using a Screwdriver.
2D
Insert 8 Plugs (#16) into holes on the sides of 2 Partition Panels (A/B)
until snug. Insert 8 Cam Locks (#13) into the holes on Back Panel (C)
with the arrow on the Cam Locks pointing out toward the closest
long edge as shown.
2E
Connect 4 holes on side edge of Back Panel (C) to 4 Cam Bolts (#12)
on Left Panel (D). Twist the
Cam Locks (#13) on Back
Panel (C) clockwise with
a Screwdriver. Insert the
Plugs (#16) from Partition
Panels (A/B) into the
pre-installed holes on
Left Panel (D) as shown.
2A
#20
#6
#1
#1
#13
#16
2D
2B
#12
#13
#2
#18
Lay the Left (D) and Right (E) Panels down and line up the 2 Sliders
(#20) with the predrilled holes as shown.
Do not pull Sliders apart.
Use 2 Screws (#1) each and Screwdriver to attach. Line up 2 Hinges
(#6) with the bent part of the hinge against Left Panel (D). Use 4
Screws (#1) and Screwdriver to attach.
2
THE BASE (CONTINUED)
2C
#18
#12
#2
2E
#13