4
4 Setup
Important: To ensure safety, read section one “ 1
For your safety!“ first.
1. Placing the unit
Make sure that the unit is placed so that there is nothing blocking the front
side filter, the cool air duct or the hot air exhaust duct.
There is only an air inlet on the front side, and the only air outlets are on
the top, so the unit can be placed with the other sides directly against a
wall, in a corner or in any other confined space.
2. Attaching the cool air duct
(1) Attaching the duct elbow
I.
Insert the duct elbow into the elbow holder, fitting the attach
-
ment notch to the black mark on the inside of the holder.
II.
After you have inserted the duct elbow into the holder, fasten
it so does not come loose by turning it to either side.
∆
Note:
Make sure that the duct elbow is correctly inserted into the
holder. If the duct elbow is not attached evenly, reattach it
correctly.
(2) Attaching the cold air duct
I.
Insert the cold air duct into the duct elbow, fitting the attach
-
ment peg on the duct to the attachment notch in the elbow,
then turn it to the right.
∆
Be sure not to insert the end with the screws!
II.
Point the duct in the direction you want the air to blow in, fix
-
ing the duct elbow with your other hand.
*
Please see page 8 for more information.
(3) Removing the duct elbow
I.
Remove the cool air duct from the elbow.
II.
Turn the elbow until the attachment notch is aligned with the
insertion mark.
III.
Remove the duct elbow by pulling it straight up from the
holder.
∆
Note:
Do not use the unit in places containing hydrochloric acid, sulphuric acid or any other corroding gas or steam.
*
There is risk of gas leak or deterioration of performance.
≥30cm
≥30cm
≥ 40cm
Insert
Duct elbow
insertion mark
(Black line)
Duct elbow
attachment notch
Filter
Duct elbow
Attachment notch
Attachment peg
Screw
Insertion mark
(Black line)
Attachment
notch
Duct elbow