1.1 g
enerAl
notes
on
sAfety
This operation manual is applicable for the machine LLC
35.
The machine may only be handled by personnel
who are qualified.
1.2 u
se
of
the
mAchine
for
PurPoses
for
which
it
is
intended
The tool is designed for grinding, milling, and deburring
metal, stone, and plastic with milling cutters and grinding
attachments.
1.3 i
ncorrect
use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion
of
conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner AG, Industriestrasse 10, CH-5242 Lupfig,
hereby declares under sole responsibility that the prod-
uct with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2006/42/
EG. Applied standards: EN ISO 12100, EN ISO 11148.
Document Agent: T. Fischer. CH-Lupfig, 10/2019.
T. Fischer/Managing Division manager
2. c
ommIssIonIng
2.1 P
rior
to
tAKing
the
mAchine
into
serVice
Use oiled compressed air (see also air
quality under section 2.3). Observe nation-
al regulations.
2.2 t
AKing
the
mAchine
into
serVice
2.2.1 t
urn
on
/t
urn
off
Tilt lock forward and press lever on plastic sleeve. Releas-
ing the lever will shut the machine down.
1. n
otes
on
s
aFety
2.3 r
Ating
dAtA
Pressure
max. 6.3bar
Power output
350W
Air consumption full load
0.67m
3
/min
Air consumption at idling
0.8m
3
/min
Setting oiler idle
about 3-4 drops/min
No-load speed
35000min
-1
Sound pressure level EN ISO 15744 76.7dB(A), K=3dB(A)
Vibration EN ISO 28927-12
5.1m/s
2
, K=2.1m/s
2
Air quality DIN ISO 8573-1
3/4/4
Lenght 322mm
Weight 0.560kg
2.4 o
PerAting
conditions
Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3.
handlIng
/ o
PeratIon
3.1 t
ools
Use only clean tools!
3.1.1 c
hAnging
/f
itting
the
tool
Hold spindle by wrench flats with open end wrench and
release/tighten down collet chuck with open end wrench.
Perform a trial run a minimum over a period of 30 seconds
without load.
3.2 w
orKing
instructions
On failure of the compressed air release the valve
lever! To achieve an optimum result, move grin-
ding tool uniformly back and forth with light pres-
sure. Excessive pressure lessens the working capability
of the machine, as well as the life of the grinding tool.
18
Summary of Contents for LLC 35
