SUHNER ABRASIVE TAM, Technical Document

Page: 20 / 60

CN
PL
CZ
FI
SE
NL
PT
ES
IT
1.1 g
enerAl nOtes On sAfety
This operation manual is applicable for the hand tool TAM.
The hand tool may only be handled by personnel
who are qualified.
It is imperative that you observe the safety instruc-
tions provided separately for the drive.
1.2 u
se Of the mAchine fOr purpOses fOr
which it is intended
The hand tool is designed for wet grinding and polishing
on artificial and natural stone with grinding, ring, and cup
wheels.
The hand tool is also suitable for polishing and brushing
surfaces with water.
The hand tool may be operated only with the ad-
ditional handle!
1.3 i
ncOrrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 d
eclArAtiOn Of incOrpOrAtiOn
The manufacturer Suhner Schweiz AG of Industriestrasse
10, CH-5242 Lupfig, hereby declares for the partly com-
pleted machinery (see reverse side for type and serial no.)
that the following fundamental requirements of the Direc-
tive 2006/42/EC are applied and fulfilled in accordance
with Annex I: 1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.3.7, 1.3.8.1,
1.5.1, 1.5.4, and 1.6.1. Technical documentation was gen-
erated for the partly completed machinery in accordance
with Annex VII of the Machinery Directive. Document
Agent: T. Fischer. Authorised sites are provided with this
technical documentation in paper or electronic form on
justified request. This partly completed machinery may
be put into operation only when the machine in which the
partly completed machinery is to be incorporated has
been ascertained to fulfil the conditions under the Ma-
chinery Directive. CH-Lupfig, 10/2019. T. Fischer/Division
manager
2. C
ommISSIoNINg
2.1 A
ssemBly instructiOns
For safety reasons a 42 V
drive must always be used
for hand tools with water
supply.
It is imperative that you read Sections 2 and 3 before you
start operating the hand tools.
1. N
oTES oN
S
aFETy
Use only hand tools, shafts, and grinding tools in perfect
condition.
Attach the hand tool to the shaft only when the drive is
switched off and has come to a stop.
Connect grinding tools only when the drive is switched off
and has come to a stop.
It is imperative that you use the guards intended for the
hand tool.
Observe the specifications applying to your country.
2.1.1 A
ttAching
/
detAching the hAnd tOOl
Press the locking button and insert the hose coupling into
the hand tool hole. Make sure that the locking button is
engaged.
Follow these instructions in reverse order to detach the
hand tool.
2.1.2 A
ttAching
/
detAching the AdditiOnAl hAndle
Move the additional handle to the position you want and
secure it at the wing nut.
2.1.3 A
ttAching
/
detAching the grinding tOOl
FR
DE
20
EN