SUHNER ABRASIVE ROTOfera, Technical Document

Page: 24 / 64

1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine
ROTOfera. The machine may only be handled by person-
nel who are qualified.
Hold power tools by insulated gripping surfaces when
performing an operation where the cutting tool may con-
tact hidden wiring or its own cord. Contact with a «live»
wire will make exposed metal parts of the tool «live» and
shock the operator.
WARNING Read all safety warnings and all
instructions.
Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
1.2 u
se of the mAchine for purposes for
which it is intended
The ROTOfera machine with adjustable speed drive is in-
tended exclusively for use as a hand-held tool for grinding
or polishing without the use of water. Make sure that only
SUHNER products are used as flexible shafts, hand tools
and abrasives. A grounding connection or grounding with
a fault current switch is required. Flexible shafts with con-
nection thread M10 (type DIN 10) or G28.
1.3 i
ncorrect use
This machine may not be used for work which
does not serve for the abrasive surface machining
or refining of metals or non-metals and near com-
bustible liquids, gases or materials.
1.4 ec
declArAtion of conformity
Otto Suhner GmbH of Trottäcker 50, D-79713 Bad Säck-
ingen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2014/30/
EU, 2006/42/EC, 2011/65/EU. Applied standards: EN ISO
12100, EN 60745, EN 55014-1, EN 55014-2, EN 61000-
3-2, EN 61000-3-3. Document Agent: T. Fischer. D-Bad
Säckingen, 10/2019.
T. Fischer/Division manager
1. N
oTES oN
S
aFETy
WARNING
To reduce the risk of injury, user must read
and understand instruction manual.
2.1 p
rior to tAking the mAchine into service
Before connecting tool to a power
source, be sure the voltage sup-
plied is the same as specified on
the name plate of the tool.
2.2 t
Aking the mAchine into service
2.2.1 f
lexible shAft
Block threaded connection with locking pin. Use lock-
ing pin to screw threaded coupling onto the shaft. Insert
locking knob and hose coupling into the connection bore.
Make sure that the locking knob snaps in.
2.2.2 A
ttAching
/
detAching the hAnd tool
Press locking knob. Slide hand tool over the hose cou-
pling. Make sure that the locking knob snaps in. For more
information please refer to the user’s manual of the hand
tool.
2.2.3 A
ttAching
/
detAching the AbrAsive
For detailed information please refer to the user’s manual
for the hand tool used. The abrasive must be fastened
snug against installed tools.
Let the abrasive run briefly at idling speed without
load. In the event of strong vibrations or other de-
ficiencies shut down the machine immediately
and rectify deficiencies or fit a new abrasive.
2. C
ommISSIoNINg
24
CN
PL
CZ
FI
SE
NL
PT
ES
IT
EN
FR
DE
EN