Page 27
Warming Drawer WWD30-2
Component Removal
4-4
#814750 - Revision A - January, 2011
Drawer Slide Removal
NOTE
:
See all Warnings and Cautions at beginning of
Section.
1. Stainless steel drawer box must be removed from
drawer.
2. Remove drawer from unit. (
Page 4-3
)
3. Remove the nuts from the threaded studs that secure
the drawer slide to the outside of the drawer frame.
(
See Figure 4-5
)
4. Remove the drawer slide assemblies from the unit
cavity by first positioning the slide so that the front
screw is visible through the access hole in the slide
and the rear screw is visible. Remove the screws and
open the slide so the center screw is visible. Remove
center screw. (
See Figure 4-6
)
5. Extract drawer slide from unit.
6. The center slide bracket is removed by lifting bracket
up off the dowel pins pressed into the floor of unit
cavity.
Drawer Front Panel Removal
NOTE
:
See all Warnings and Cautions at beginning of
Section.
1. Stainless steel drawer box must be removed from
drawer.
2. Open drawer to the full open position.
3. Extract screws along the bottom inside edge of front
panel. (
See Figure 4-7
)
4. Extract screws along the top flange of front panel.
5. Lift front drawer panel off the drawer mounting panel.
6. Handle mounting screws are accessible from the
inside face of the front panel. Remove the drawer
handle by extracting the mounting screws that secure
the handle and spacer blocks to front panel.
7. Once drawer front has been removed, door mounting
panel can be removed by extracting the screws from
face of the drawer mounting panel. (
See Figure 4-8
)
Figure 4-7. Drawer Front Panel Removal
Figure 4-8. Door Mounting Plate Removal
Extract Screws
Extract Screws
Extract Screws
From Inside
Flange
Figure 4-5. Drawer Slide Removal
Bottom of Drawer Shown
Figure 4-6. Drawer Slide Removal
Interior of Unit Cavity Shown
Remove Screws
Remove Nuts
ELECTRICAL SHOCK HAZARD - DISCONNECT
ELECTRICAL SUPPLY TO UNIT BEFORE ATTEMPT-
ING THE FOLLOWING PROCEDURES.
