Subaru Impreza 2016, Manual

Page: 497 / 600

Black plate (511,1)
一 般
Model "A1250GE-A" EDITED: 2015/ 8/ 4
3. Pull out the level gauge, wipe it clean,
and insert it again.
4. Be sure the level gauge is correctly
inserted until it stops with the graphic
symbol
“ ”
on its top appearing as
shown in the illustration.
1) Full level
2) Low level
3) Approximately 1.0 liter (1.1 US qt, 0.9
Imp qt) from low level to full level
5. Pull out the level gauge again.
6. Check the oil level on the level gauge.
If it is below the low level, it is necessary to
add engine oil to bring the level up to the
full level.
7. To add engine oil, remove the engine
oil filler cap and slowly pour engine oil
through the filler neck.
NOTE
To prevent overfilling the engine oil, do
not add any additional oil above the full
level.
8. Restart the engine and keep the
engine idling until the idle speed stabi-
lizes.
9. Stop the engine. After 5 minutes,
check the oil level again.
&
Changing the oil and oil filter
Change the oil and oil filter according to
the maintenance schedule.
The engine oil and oil filter must be
changed more frequently than listed in
the maintenance schedule, when short
trips are frequently made, when towing a
trailer, or when driving in extremely cold
weather.
NOTE
.
Changing the engine oil and oil filter
should be performed by a well-trained
expert. Contact your SUBARU dealer
for changing the engine oil and oil filter.
Fully trained mechanics are on standby
at a SUBARU dealer to utilize the
special tools, spare parts and recom-
mended oil for this work, and also,
used oils are properly disposed of.
.
For diesel engine models, the en-
gine oil replacement data that is stored
in the on-board computer should be
reset using a special tool every time
engine oil and the oil filter are replaced.
If the data is not reset, the diesel
particulate filter warning light does
not operate properly. To reset the data
of the on-board computer without a
special tool, see the following item.
!
Resetting the oil replacement data
(diesel engine models)
NOTE
If the resetting procedure was unsuc-
cessful, repeat steps 1) through 5) after
performing the following items.
–
Wait for 30 seconds with engine
idling.
–
Turn the engine off, and restart the
engine after waiting 15 seconds.
After engine oil and the oil filter have been
replaced, the oil replacement data should
be reset. To reset the data without a
special tool, perform the following proce-
dures.
1. Depress the brake pedal.
2. Start the engine, and keep it in idling.
3. Release the clutch pedal.
4. With depressing the brake pedal, per-
form the following:
(1) Press the rear window defogger
Maintenance and service/Engine oil
11-17
–
CONTINUED
–
11