Subaru Impreza 2016, Manual

Page: 61 / 600

Black plate (61,1)
一 般
Model "A1250GE-A" EDITED: 2015/ 8/ 4
child suffering personal injury in the
event of an accident may be in-
creased.
!
Preparation for installing child re-
straint system
First check if the Automatic Locking
Retractor (ALR) is equipped for the
seatbelts of the vehicle according to the
following procedure.
1. Draw out the seatbelt completely.
2. Retract the seatbelt even slightly and
try to draw out the seatbelt again.
3. If the seatbelt is locked in that position
and cannot be extended, it indicates that
an ALR is equipped for the seatbelt.
When the seatbelt is retracted fully, the
ALR mode is canceled and the Emer-
gency Locking Retractor (ELR) mode is
restored.
NOTE
.
For details about the ELR, refer to
“
Emergency Locking Retractor (ELR)
”
F
1-13.
.
For details about the ALR, refer to
“
Automatic Locking Retractor/Emer-
gency Locking Retractor (ALR/ELR)
(Australia models)
” F
1-13.
!
Installing a rearward facing child
restraint
NOTE
.
For models with ALR:
If using ALR mode is recommended by
the manufacturer
’
s instructions sup-
plied with the child restraint system,
use ALR mode.
1) Lock-off device
2) Locking clip
.
If using the lock-off device or the
locking clip is recommended by the
manufacturer
’
s instructions supplied
with the child restraint system, use
the lock-off device or the locking clip
to secure the child restraint system.
Through the following steps, the child
restraint system is fastened with a seatbelt
that is set to ELR mode.
1. Place the child restraint system in the
rear seating position.
2. Run the lap and shoulder belt through
or around the child restraint system
following the instructions provided by its
manufacturer.
3. Insert the tongue plate into the buckle
until you hear a click.
Seat, seatbelt and SRS airbags/Child restraint systems
1-29
–
CONTINUED
–
1