PN: H001SAJ200 REV. - 3/10/10 SUBARU OF AMERICA
2
1. Turn car ignition to the off position until
requested to turn on in step 10.
2. On the driver’s side rear quarter-panel
interior trim, place and tape the provided
template as shown (Cut out template on
page 10), aligning the template into the 3
corners. Once aligned, mark hole centers
and remove template prior to drilling. Using
a right angle drill, drill 4 holes with a 3/8” drill
with a 1/8” drill stop. Remove burrs from
holes if necessary. (Please note bottom
dock must clear the rear cargo tray.)
3. Using the provided four rubber well
nuts, push nuts into all four holes until
seated against the quarter panel interior
trim.
3.
Instructions: Outback
