5
3. INVERTER UNIT INSTALLATION
CAUTION
1. Cut off Double sided tape
⑨
as shown in
left picture.
2. Attach Brackets
⑥
to Inverter
⑤
with four
Screws
⑦
.
3. Apply Double sided tape
⑨
(A)
to
the
bottom of Brackets
⑥
.
4. Locate position where Inverter
⑤
will be
installed.
5. Pull up carpet and de-grease floor surface
with Isopropyl alcohol where Inverter
⑤
will
be installed.
6. Remove liner from Double-sided tape
⑨ and
apply
to
bottom of both Brackets
⑥
.
7. Install Inverter
⑤
to center of cut area with
connector facing driver.
8. Apply on the Inverter
⑤ after apply the
Double sided tape
⑨
(B) on the Insulator.
2. TRIM FLOOR CARPET
CAUTION
When cutting out the floor carpet, take care
that you do not cut the vehicle harness.
Scraps of insulation from the floor carpet
may cause the unit to become clogged,
so remove all scraps after work is complete.
Insulator
Double sided
tape position
FRONT
Remove insulator
completely
(Passenger side,under seat area)
1. Apply masking tape to the floor carpet in the
areas shown in the image on the left.
2. Cut out the floor carpet around the outside
edge of the masking tape.
3. Lift up the floor carpet and cut out part of the
insulation. Take care that there are no
scraps of insulation around areas where
butyl tape has been applied.
A
B
20mm
50mm
Cut off
Double sided tape
Screws
Screws
Bracket
Bracket
Double sided tape (A)
Inverter
FRONT
Mounting holes
Double sided tape (B)
Insulator
5
FRONT
Marking tape
Cuting line
Align with left edge of right
factory harness cut out
