Subaru 2013 Forester, Owner'S Manual

Page: 412 / 529

Black plate (418,1)
一 般
Model "A8190GE-C" EDITED: 2013/ 3/ 29
9-16
In case of emergency/Access key
–
if access key does not operate properly
Access key
–
if access key
does not operate properly
CAUTION
Keep metallic objects, magnetic
sources and signal transmitters
away from the area between the
access key and the push-button
ignition switch. They may interfere
with the communication between
the access key and the push-button
ignition switch.
If the locking/unlocking procedures, power
switch procedures or engine start proce-
dures cannot be operated because of
strong radio signals in the surrounding
area or low battery condition of the access
key, perform the following procedure.
When the battery of the access key is
discharged, replace it with a new one.
Refer to
“
Replacing battery of access key
”
F
11-54.
&
Locking and unlocking
1) Release button
2) Mechanical key
While pressing the release button of the
access key, take out the mechanical key.
Lock or unlock the driver
’
s door with the
mechanical key.
NOTE
After locking or unlocking, be sure to
reinsert the mechanical key into the
access key.
&
Switching power
1. Apply the parking brake.
2. Shift the shift lever into neutral (MT
models) or the select lever into the
“
P
”
position (CVT models).
3. Depress the clutch pedal (MT models)
or brake pedal (CVT models).
4. Hold the access key with the buttons
facing you, and touch the push-button
ignition switch with it.
When the communication between the
access key and the vehicle is completed,
a chime (ding) will sound, and the opera-
tion indicator on the push-button ignition
switch illuminates in green. At the same
time, the status of the push-button ignition
switch changes to either of the following.
.
When the keyless access with push-
button start system is deactivated:
“
ACC
”
.
Under other conditions:
“
ON
”
5. When the keyless access with push-
button start system is deactivated, press
the push-button ignition switch with the