Subaru 2010 Impreza, Owner'S Manual

Page: 239 / 420

7-14
Starting and operating
the turn signal lights will flash 2 times to
indicate Confirmation Horn Chirps are
“
ON
”
. Depressing the brake pedal repeat-
edly will toggle the feature ON or OFF
each time.
7. To exit the remote engine start trans-
mitter and feature programming mode,
turn the ignition switch to the
“
LOCK
”
position, remove the key from the ignition
switch and test operation of the remote
engine start transmitter(s) and horn con-
firmation feature.
&
System maintenance
!
Changing the batteries
CAUTION
.
Do not let dust, oil or water get on
or in the remote engine start
transmitter when replacing the
battery.
.
Be careful not to damage the
printed circuit board in the re-
mote engine start transmitter
when replacing the battery.
.
Be careful not to allow children to
touch the battery and any re-
moved parts; children could
swallow them.
.
There is a danger of explosion if
an incorrect replacement battery
is used. Replace only with the
same or equivalent type of bat-
tery.
.
Batteries should not be exposed
to excessive heat such as sun-
shine, fire or the like.
The two 3-volt lithium batteries (model
CR-1220 ) supplied in your remote engine
start transmitter should last approximately
3 years, depending on usage. When the
batteries begin to weaken, you will notice
a decrease in range (distance from the
vehicle that your remote engine start
system operates). Follow the instructions
below to change the remote engine start
transmitter batteries.
1. Carefully pry the remote engine start
transmitter halves apart using a small flat-
head screwdriver.