IMPREZA U.S.A. (E)
10-32
Replacement of windshield wiper blades
Grease, wax, insects, or other materials on the windshield or the wiper
blade results in jerky wiper operation and streaking on the glass. If you
cannot remove those streaks after operating the windshield washer or if
the wiper operation is jerky, clean the outer surface of the windshield (or
rear window) and the wiper blades using a sponge or soft cloth with a
neutral detergent or mild-abrasive cleaner. After cleaning, rinse the wind-
shield and wiper blades with clean water. The windshield is clean if
beads do not form when you rinse the windshield with water.
CAUTION
Do not clean the wiper blades with gasoline or a solvent, such as
paint thinner or benzene. This will cause deterioration of the
wiper blades.
If you cannot eliminate the streaking ever after following this method,
replace the wiper blades using the following procedures:
1. Raise the wiper arm off the windshield.
2. Remove the wiper blade assembly by holding its pivot area and push-
ing it in the direction shown by the arrow while depressing the wiper
blade stopper.
HS0190
Stopper
3. Grasp the locked end of the blade rubber assembly and pull it firmly
until the stoppers on the rubber are free of the metal support.
