13
[recoIL stArter MoDeL]
•
Pull the starter handle slowly until resistance is felt. This is
the «compression» point.
•
Return the handle to its original position and then pull swiftly.
If the engine fails to start after several attempts, repeat above
procedures with choke knob returned to open.
•
Do not fully pull out the rope.
•
After starting, allow the starter handle to return to its original
position while still holding the handle.
After the engine started, return the choke knob gradually to “OPeN” position.
Warm up the engine without a load for a few minutes.
[eLectrIcAL stArter MoDeL]
1. Insert the key inside the switch key and turn it to the ‘‘ ’’ position.
Then turn it right (START) in order to start the engine.
2. When the engine started, turn the choke knob slowly to make the
engine run and keep it to the full normal position. Do no open
it quickly when the engine is cold or the outside temperature is
cold, because the engine might stop. Let the engine warm for few
minutes without load.
•
Do not let the electrical running for more than 5 seconds, even if the
engine is not working;
•
I the engine doesn’t start, wait for roughly 10 secondw before starting
again;
•
Never turn the switch key to the Start position when the engine is running.
Summary of Contents for WORMS EXPLORER 6510 XL27
Page 23: ...23...
