Ice and Water Dispenser
For dispenser models BI-42SD and BI-48SD, the auto-
matic ice and water dispenser gives you both ice and
chilled water without having to open doors.
ICE DISPENSER OPERATION
To operate the ice dispenser for models BI-42SD and
BI-48SD, set a glass on the water grille of the glasswell,
and press and hold the ICE key pad on the glasswell until
you have the ice you need. For larger quantities of ice,
open the refrigerator door and place an ice container
under the dispenser chute, then press the BULK ICE key
pad on the left-hand wall inside the refrigerator section.
Refer to the illustrations below.
After initial ice maker start-up, discard the first few batches
of ice, they may be discolored by the new plumbing.
ICE DISPENSING
Models BI-42SD and BI-48SD have a feature that limits
the maximum amount of ice that is dispensed each time
the ICE key pad on the glasswell is pressed.
To dispense ice, hold down the ICE key pad for approxi-
mately two seconds. The dispenser will meter out ice for
about two seconds, collect the ice directly above the
glass, then drop the ice into the glass. If less ice is
desired, hold the ICE key pad down for less than two
seconds. If more ice is desired, hold the ICE key pad
down until the dispensing cycle repeats.
Built-In Use & Care
20
Use a sturdy glass to catch ice crescents. Fragile
glasses can break. Also, to avoid breakage, make sure
that the glass is sitting vertically on the water grille.
IMPORTANT NOTE:
Be sure that dispenser key pads are
clean and dry when pressed to avoid problems with the
dispenser operation.
ICE DISPENSER OPERATING TIPS
•
If there is no ice, make sure the ice maker system is
turned on and
indicator is illuminated in the control
center display panel.
•
Make sure that the water filter cartridge is in place or
that the water filtration system is in bypass mode.
A separate bypass plug is required to bypass the
water filtration system. This bypass plug is available
through your authorized Sub-Zero dealer. Refer to the
installation instructions provided with the bypass plug.
•
Make sure there is a supply of ice in the ice container.
Refer to ice container removal on page 15.
•
Make sure the ice container is all the way in and
engaging the auger motor at the back of the container.
If it is not all the way back, push on the ice container
and press the ICE key pad on the glasswell at the
same time.
•
Press the ICE key pad on the glasswell. If you do not
hear auger motor noise, wait five minutes, then try
again. If you do not hear auger noise after the second
try, contact Sub-Zero factory certified service.
•
If the ice dispenser is not used for a long period, the
ice may fuse together. To avoid this, empty the ice
container as needed.
ICE
WATER
LIGHT
WATER
GRILLE
BEZEL
LOCK
INDICATOR
Dispenser glasswell.
Bulk ice dispenser.
BULK ICE
KEY PAD
