ASSEMBLY INSTRUCTIONS
Page5
STEP3
Position one of the Crossbar Ends (Part #1) on its side.
Tighten the screws(Part #16) from the top.
If you drop a screw inside the Crossbar End (Part #1), simply tilt
to retrieve the screw.
Using the Allen Wrench, rotate each screw just a few turns.
Repeat Step 4 with the other assembly.
If you are having difficulty inserting any of the
screws from Step 3 or 4, it is because some of
the installed screws are too tight.
Slide the two (2) Crossbar center Rails (Part #4)
into the two Crossbar Ends, (Part #1)
ensuring:
a) the slots Face inward
b) the slot is closer to top edge of the
Crossbar center Rail (Part #4) when
the assembly is upside down (see inset)
STEP4
