STX Mega-Steam 4000 SX2, Instruction Manual

Page: 13 / 20

- 11 -
TIPS for fabric steam wrinkle control, deodorizing and sanitizing:
• Check to ensure that fabric will not be damaged by high heat.
• Hold the garment or fabric with your hand or with a clothes
hanger.
• Steam the garment or fabric with the steam gun starting at the
bottom and working upward toward the top of the material without
direct steam application to any one point for long periods of time.
Be careful not to direct the steam toward your exposed skin.
Scalding will occur if care is not taken.
• Gently tug at the base (the sleeves for example) of the garment
intermittently to stretch out the wrinkles as needed.
• Collars may take additional steaming to control wrinkles.
6. The Large Floor Brush Accessory - suggested uses: floor sanitizing &
deodorizing, less aggressive floor tile cleaning, etc.
The floor brush accessory attaches to an extension tube via the floor
brush adapter. To connect the floor brush adapter to the floor brush
accessory locate and line up the arrows on each component. Insert
the floor brush adapter into the floor brush accessory (See pictures
below). Turn the floor brush adapter one-half turn (180°) to secure
the two units together. The completed unit then can be attached to an
extension tube as previously described.
NOTE:
• To remove the floor brush accessory and floor brush
adapter, simply reverse the process.
• Three large cotton booties have been provided to cover the
bristles on the floor brush accessory, if desired. To place
the large cotton booties, simply stretch the bootie over the
brush end of the floor brush accessory and push down on
the spring tabs on either side of the top of the floor brush
accessory to secure the booties.
Adapter & Floor
Brush Accessory
Floor Brush
Accessory Aligned to
Adapter
Adapter Twisted
to Fully Connect
to Floor Brush
Accessory