STULZ UltraWater 3-stage reverse osmosis system SUW
Safety instructions
© STULZ GmbH, Hamburg
-
7
-
2.
SAFETY INSTRUCTIONS
Please note the following basic safety instructions. The safety instructions are intended to prevent personal
injury and damage to property. The system operator must ensure that the basic safety instructions are noted
and adhered to. Make sure that the system operator and all persons who work on the system on their own
responsibility have fully read and understood the documentation. If anything is unclear or you require ad
-
ditional information, please ring STULZ Technical Support.
•
Non-compliance with the safety instructions can result in danger to personnel, to the environment and to
the system. Failure to comply with the safety instructions will result in the loss of any claims for damages.
•
Pay attention to the safety instructions set out in this technical documentation, the applicable national
health and safety regulations and company work, operating and safety instructions.
•
Safe operation of the system is only ensured if it is used in accordance with its intended use. The limit
values set out in the technical data must never be exceeded.
2.1. Preliminary comments
The basic safety instructions below apply to the STULZ UltraWater. Pay attention to the additional warning
notes in the individual sections of this technical document.
2.2. Proper use
STULZ reverse osmosis systems are approved solely for the preparation of particle-free water. Depending
on the type of system, the untreated water may have a low salt content (tap water and surface water has
up to approx. 1000 mg/l). If STULZ systems are used for water of a different quality, it is essential that you
first contact STULZ. Generally, drinking water that conforms to the German Drinking Water Regulations is
suitable for use in reverse osmosis systems. In some cases (e.g. if the Silt Density Index is higher than 3),
suitable pretreatment (softening, hardness stabilization) must be performed beforehand.
The STULZ UltraWater is intended solely for indoor use, and may only be used with compatible products.
Any other use besides or beyond this shall be regarded as improper use. STULZ cannot be held liable for
damages resulting from the above. The plant operator is the sole bearer of the risk.
The STULZ UltraWater may only be used in accordance with the instructions in the technical documentation
from STULZ.
2.3. Unauthorized operating practices
Safe operation of the supplied system is only ensured if it is used correctly in accordance with the “Proper
use” section of the Technical Manual. The limit values set out in the technical data and test record must never
be exceeded under any circumstances.
The STULZ UltraWater is designed for technical use, not for the treatment of drinking water!