3
A. Channel
1. MIC/LINE CHANNEL (CH1-6)
Balanced XLR input connector (1
ground
2
hot
3
cold).
CLUBXS8 Is designed with 4 low noise mic pre-amp (CLUBXS10
has 6) and phantom power, 45dB gain and >100 dB S/N ratio. The
phantom power is used for condenser mic. If you use dynamic mic,
please turn off phantom power first. These channels are designed
with 1/4inch TRS bal/unbal line ine connectors to connect with
keyboard, electric drum, DSP, etc.
3. COMP
2. Gain control
It adjusts input signal level to balance the S/N ratio and dynamic
range. To get best effect, adjust this knob: make PEAK LED flashes
sometimes to avoid channel distortion.
Mic input gain range:
-16~-60dB, line in gainrange: +10~ -34.
5. EQ control
1
2
7
8
10
3
5
6
9
4
4. HPF
It turns on/off the HPF with 18 dB octave to activate 80 Hz LF filter.
You can also use it to reduce mains hum noise or stage mic noise.
Hi
when you set it to max,
12 KHZ frequency level 15dB.
To min, and the 12 kHz frequency levelcuts -15dB
MID
when you set it to max, 2.5
KHZ frequency level 15dB.
To min, and the 2.5 kHz frequency level cuts -15dB.
LOW
when you set it to max, 4.5
HZ frequency level 15dB.
To min, and the 4.5 kHz frequency level cuts -15dB
6. AUX-DSP
7. PAN
Set it to middle position, then sound image will be in the middle of
the stage. It can also adjust the left/right output signal.
8. PEAK LED
When signal reaches the level of clipping level deducted 3dB,
PEAK LED lights up red.
9. MUTE & LED
Each channel is designed with MUTE button. Press it to mute
the channel. The mute LED lights up.
It adjusts channel compression. Turn clockwise to increase
compression ratio and gain will adjust automatically.
B
L
O
C
K
D
IA
G
R
A
M
10
These two knobs are used to the level of signal sent to AUX-DSP
BUS, and then to external DSP, or to built-in DSP module. DSP knob
can also adjust channel level.
Summary of Contents for CLUBXS10
Page 1: ...CLUBXS8 10 CLUBXS...
