Studer Xtender BTS-01, User Manual

Page: 40 / 49

STUDER Innotec
Xtender
38 V.3.1.0 User manual
Pos. Denomination Description Comment
13 AC Input
Connection terminals for the
alternative power supply
(generator or public network)
See chapter 4.5.7 - p. 17.
Note: It is imperative that the PE
terminal be connected.
14 AC Output
Connection terminals for the
device output. See chapter 4.5.6 - p. 17.
Note: Increased voltages may appear
on the terminals, even in the absence
of voltage at the input of the inverter.
17 --
Supplementary terminal for
protective earth
This terminal can be used if the
required earth cable cross-section is
too big to be connected in the
terminal 13 or 14
18 -- Mounting hook-up
19
Access shutter to the top
fastening screw.
Full tightening of the top fastening
screw may be required in mobile
application or in case of heavy
vibration of the support of the
apparatus.
15 CONTROL AND DISPLAY PARTS FOR THE XTENDER (FIG. 4B)
See chapter 7.2 - p. 29.
Pos. Denomination Description Comments
41
ON/OFF button The ON/OFF button allows the start up or complete
stoppage of the system such as it has been
programmed. When there are several units in the
same system, each unit must be started up or
stopped individually using this button.
42 OFF
Light indicator
for stoppage
of the unit
When the light indicator flashes it indicates the cause
of the stoppage of the unit, its imminent stoppage or
the limitation of its rated power output according to
chapter 7.2 - p.29.
43 ON
Light indicator
showing that
the equipment
is in operation
This indicator is glowing continuously when the
device is working. It flashes when the equipment is at
a temporary stop. Note: The equipment will restart
automatically when the conditions that led to the
temporary stoppage have gone away.
44 Charge
Light indicator
showing that
the battery is
being charged
This indicator is glowing continuously when the
charger is in operation and has not yet reached the
absorption phase.
It flashes twice during the absorption phase and
once during the maintenance phase.
If smart boost mode has been activated it is possible
that this indicator will go out temporarily when source
backup is required by users. (See chapter
6.2.6
- p.
23
)
45 AC in
Light indicator
showing the
presence of
correct and
synchronised
input voltage
This indicator is glowing continuously when an
alternative voltage with correct values is present at
the AC IN input (13) of the device and the current
limit {1107) set by the user has not been reached. It
flashes when this limit is reached (see chapter 6.2.5 –
p. 23).