Stryker SwitchPoint Infinity 2, Operation And Maintenance Manual, Page: 23 / 82

21
8. Routing Video
The options on the Video Router screen allow you to route images from various cameras or video input devices in
the iSuite® OR to devices or monitors connected to the SwitchPoint Infinity® 2 Control System. This screen can be
used to select which video source to direct to a remote room or off-site location using the Video Network Hub™.
This screen can be accessed by selecting the “Video” tab at the top of the screen.
The SwitchPoint Infinity® 2 Control System manages video routing as a chain of events. Once a video source is
selected, it can be routed to a number of devices or displays in a row. This simplifies the process and allows the
same input source to be viewed and recorded in multiple ways.
The SwitchPoint Infinity® 2 Control System gives special distinction to devices such as the SDC, Sidne™, Printers,
and VCRs. These devices are capable of receiving video signals, but their output can be re-routed to a display so
that the surgeon can view what is currently being recorded on a given documentation device.
There are three ways in which video can be routed, each of which will be described in the sections that follow.
8.1 Simple Routing
The main Video screen appears similar to the one shown below, and is also known as the “Simple Routing” page.
This screen contains four main components: the sources are listed on the left side of the screen; the devices
through which the sources can be routed are listed at the top of the screen; the displays on which the video signal
can be displayed are located on the right side of the screen; and the video stream being routed will be displayed in
the video preview pane in the center of the screen.
StockCheck.com