Stryker ST1 Series, Operation Manual

Page: 25 / 42

A
B
C
A
F Fiig gu urre e 1 12 2 –– P Po ossiittiio on niin ng g tth he e 2 2--sstta ag ge e p pe errm ma an ne en nttllyy a atttta acch he ed d IIV V p po olle e
P Po ossiittiio on niin ng g tth he e tth hrre ee e--sstta ag ge e p pe errm ma an ne en nttllyy a atttta acch he ed d IIV V p po olle e o op pttiio on n
W WA AR RN NIIN NG G
• Do not hang IV bags that exceed the safe working load of 18 kg on the IV pole.
• Do not hang IV bags that exceed the safe working load of 4.5 kg on any hanger on the IV pole.
• Always make sure that the IV pole is at a low height to pass through door openings when you transport a patient.
• Do not use the IV pole as a push/pull device. Product damage may occur.
You can purchase the product with the three-stage IV pole option permanently attached at the head end, foot end, or both
ends of the product. The IV pole is equipped with a telescopic pole that extends to provide a second and third height
position. You can also fold and store the IV pole when not in use.
To position the three-stage IV pole (Figure 13):
1. Lift and pivot the pole from the storage position.
2. Push the IV pole down until the pole locks in place.
3. To raise the height of the IV pole, pull up on the telescoping portion (A) until the pole locks into place at the fully raised
position.
4. For a higher IV pole, pull up on section (B). Release section (B) at any desired height to lock the pole in place.
5. Rotate the IV hangers (C) to the desired position and hang the IV bags.
6. To lower the IV pole, push up on the yellow portion of the grip (D) while holding on to section (B) until the pole lowers.
7. Turn the latch (E) and lower the IV pole telescoping portion.
KK-6300-en Rev 03 21 EN