• During reinstall, insert the sensor hose and once you hit a stop, continue to push until you reach a hard stop.
4. Disconnect the cable (AN) from the sensor board (AB) (Figure 23).
5. Using needle nose pliers, lift up slightly, disconnect the sensor board (AB) from the three plastic standoffs (Figure 23).
NNoottee -- During reinstall, align the standoffs to the main board and press near the standoffs to seat the main board. Do not
bend the board.
FFiigguurree 2233 –– SSeennssoorr bbooaarrdd
6. Remove and discard the sensor board.
7. Reverse steps to reinstall.
NNoottee
• During reinstall, align the VVeellccrroo® patches.
• After installation, remove the zipper pull tool or equivalent from the zipper.
• Cover the zipper with the support surface cover watershed.
• Do not dispose of as unsorted municipal waste. See your local distributor for return or collection systems available in
your country.
8. Run the leak diagnostic test. See
Accessing the Isolibrium Diagnostic Menu
in the IInnTToouucchh Maintenance Manual.
9. Verify proper operation before you return the product to service.
RReessoonnaattoorr rreeppllaacceem
meenntt
TToooollss rreeqquuiirreedd::
• Zipper pull tool or equivalent
• Diagonal pliers
PPrroocceedduurree::
1. See
2. Using diagonal pliers, cut the cable ties (BG) from the inlet and outlet hoses of the resonator (Figure 24). Discard the
cable ties.
NNoottee -- During installation, before you cut the end off of the cable tie, use the diagonal pliers to pry the slack out of the
cable tie (one to two clicks).
2972-009-002 Rev AA.0
45
EN
Summary of Contents for Isolibrium 2972
