Return To Table of Contents
www.stryker.com
2031-009-005 REV A
29
Cleaning
Hand wash all surfaces of the bed with warm water and mild detergent. DRY THOROUGHLY. Do not steam clean or
hose off the Epic II Bed. Do not immerse any part of the bed. Some of the internal parts of the bed are electric and
may be damaged by exposure to water.
Suggested cleaners for bed surfaces:
Quaternary Cleaners (active ingredient − ammonium chloride) (excluding Virex® TB)
Phenolic Cleaners (active ingredient − o−phenylphenol)
Chlorinated Bleach Solution (5.25% − less than 1 part bleach to 100 parts water)
Avoid over saturation and ensure the product does not stay wet longer than the chemical manufacturer’s guidelines
for proper disinfecting.
CAUTION
SOME CLEANING PRODUCTS ARE CORROSIVE IN NATURE AND MAY CAUSE DAMAGE TO THE PRODUCT IF
USED IMPROPERLY. If the products described above are used to clean Stryker patient care equipment, measures
must be taken to insure the beds are wiped with a damp cloth soaked in clean water and thoroughly dried following
cleaning. Failure to properly rinse and dry the beds will leave a corrosive residue on the surface of the bed, possibly
causing premature corrosion of critical components. Failure to follow the above directions when using these types of
cleaners may void this product’s warranty.
For mattress cleaning instructions, please see the tag on the mattress, or contact the mattress manufacturer.
Clean Velcro
®
AFTER EACH USE. Saturate Velcro
®
with disinfectant and allow disinfectant to evaporate. (Appropriate
disinfectant for nylon Velcro
®
should be determined by the hospital.
Virex® TB is not an approved cleaning agent for this product. Do not use for bed cleaning.
Summary of Contents for EPIC II 2031
Page 2: ......
Page 26: ...Return To Table of Contents 26 2031 009 005 REV A www stryker com Notes ...
Page 40: ......
