33
Edit
- HUMMER 4
Set Speed High
8001
Set Speed Low
2000
Set Speed Osc
2400
Direction FWD
Mode High
Run Mode
Var
Accelerate 80
Brake 0
Osc Turns
3
From the Modify File screen, touch the View (magnifying glass) button to view the preference settings of a selected
handpiece within a user preference file.
To Manage User Preference Folders and Files: - Advance User Mode Only
To View Settings
Edit Settings
Touch arrow buttons to
scroll through and
highlight a handpiece
setting. Touch EDIT
button to change the
setting.
To Edit Settings
From the Edit screen, touch the EDIT button to modify the setting within the user preference file only (console defaults
remain unchanged).
2400
6K MICRO SHAVER
Edit maximum speed setting
Mode
Figure 33. View Handpiece Settings Screen
Figure 34. Typical Edit Setting Screen
NOTE:
Before you begin, you must create a user preference file, load the file into the User Preference Favorites
list and select the file. You must also be in the Advanced User Mode. For specific screen information, see the
relevant sections of
To Manage User Preference Files - Advanced User Mode Only
and
Replace and Select a User
Preference Favorite
s.
To Edit Settings - Radio Frequency Identification (RFID) Handpiece and Cutters
1.
Once you have selected the file to be edited in the User Preference Favorite screen, connect a RFID-enabled
handpiece, for example a Formula Shaver, to the console.
2.
Respond to any pop-ups as required.
3.
Plug in an RFID-enabled cutter and verify the cutter is recognized. The cutter name should appear on the HOME
screen.
4.
Edit speed set points for all directions and operating modes, as well as acceleration, brake, number of
oscillating turns, and run mode.
5.
Remove the cutter from the handpiece.
6.
Repeat steps 3 through 5 for any additional cutters up to 30 cutters maximum.
7.
From the User Preference Favorite screen, touch the SAVE CURRENT SETTINGS button to save all the cutter
settings to the selected user preference file.
8.
Return to HOME screen and proceed as required.
