EN-10
Swivel Adjustment Lever
Making Roll Stand Adjustments
CAUTION:
DO NOT MOVE ROLL STAND WHILE DISPLAY IS IN HIGHEST VERTICAL POSITION. LOWER
DISPLAY BEFORE MOVING ROLL STAND.
Height Adjustment
CAUTION:
The Roll Stand Post operates by pneumatic pressure. The Post will travel upward when the Foot Pedal is
pressed. Ensure that nothing will obstruct upward travel before pressing the Foot Pedal.
1. Press and hold the Foot Pedal to release the Post for positioning.
2. Move the mounted instrument to the desired height and release the Foot
Pedal to lock the Post in position.
Locking the Casters
There are two (2) locking casters on the Roll Stand. Locking casters
are identified by labels on the top surface of two (2) legs of the Roll
Stand Base.
Press lever downward to lock a caster. Lift lever to unlock.
Swiveling the Flat Panel
Loosen the Swivel Adjustment Lever. Swivel flat panel to desired position.
Tighten Swivel Adjustment Lever to lock flat panel in position.
Tilting the Flat Panel and Adjusting Tilt Tension
Tilting the Flat Panel
Grasp flat panel and tilt to desired position.
Note:
If tilt position cannot be maintained, see
Increasing Tilt Tension
section
.
If instrument is difficult to tilt, see
Decreasing Tilt Tension
section
.
Decreasing Tilt Tension
Using the 9/64'' Hex Wrench, decrease tension by turning
both
tilt tension screws the same number of turns counter
clockwise.
Lock
Unlock
Summary of Contents for 240-099-109
Page 1: ...Flat Panel Roll Stand REF 240 099 109 240 099 110 简体中文 日本語 한국어 ...
Page 2: ......
Page 4: ...4 ...
