Page 11 of 15
Electric shock hazard. Do not use with an extension cord near water or where water may
accumulate. Do not use in wet or damp areas.
Electric shock hazard. Do not use while standing on wet or damp areas.
Keep lamp at least 16 feet (5m) from pools and spas.
Keep plugs and receptacles dry. For use only on GFCI protected circuits in accordance with article
590 of the NEC.
Do not submerge the light in water. The light is not waterproof. Use extreme caution in any wet
location.
Risk of fire. Keep away from combustibles. Do not leave the light unattended when it is plugged
into an electrical outlet. Turn off the light, and unplug it from its electrical outlet before leaving.
Do not use in the proximity of vehicles or equipment, when there are flammable liquids present.
Burn Hazard. Do not touch hot surfaces.
Unplug and allow to cool before replacing bulb. Bulb gets HOT quickly! Only contact On/Off
Button/Plug when turning on. Do not touch hot lens, guard, or enclosure. Do not remain close to
the light if skin feels warm. Do not look directly at lighted lamp.
Do not operate without guard.
Do not touch the bulb at any time. Use a soft cloth. Oil from your skin may damage the bulb.
People with pacemakers should consult their physician(s) before use. Electromagnetic fields in
close proximity to heart pacemaker could cause pacemaker interference or pacemaker failure. In
addition, people with pacemakers should:
Avoid operating alone.
Properly maintain and inspect to avoid electrical shock.
Properly ground the power cord. Ground Fault Circuit Interrupter (GFCI) should also be
implemented – it prevents sustained electrical shock.
After Each Use
⚠
WARNING
Unplug and allow to cool before replacing bulb. Bulb gets HOT quickly! Only contact On/Off
Button/Plug when turning on. Do not touch hot lens, guard, or enclosure. Do not remain close to
the light if skin feels warm. Do not look directly at lighted lamp.
Do not touch the bulb with bare hands. Oil from skin will drastically shorten the life span of the
bulb if not cleaned with rubbing alcohol and allowed to dry before use.
Handle the bulb with a soft, clean cloth or clean work gloves.
Allow light set to cool and wipe external surfaces with a clean cloth.
