surewerx.com
3
!
SET UP
ASSEMBLY
1. Connect two piece handle assembly, ensure that internal and external rods mate properly.
Use screw provided to secure outer handle tube and cotter pin to secure external handle locator rod.
2. Loosen handle retaining bolt from yoke assembly, insert handle assembly and handle locator rod into
yoke assembly. NOTE: Rotate release knob at top of handle to ensure that the internal handle rod is
engaged within the yoke assembly fully. Tighten handle retaining bolt on yoke assembly.
3. Extract air hose assembly from initial storage position and attach to top of handle.
4. Add a few drops of air tool lubricant into air valve assembly.
AIR PURGE
1. Open release valve by rotating release knob at top of handle counterclockwise two turns.
2. Remove oil filler plug on side of hydraulic unit, ensure oil level is just below filler plug hole,
reinstall plug.
3. Depress the air valve for 30 seconds.
4. Close release valve by rotating release knob at top of handle clockwise until firm.
Do Not Overtighten.
5. Depress air valve until ram is fully extended.
6. Repeat if necessary.
LIFTING
1. Secure the vehicle by chocking wheels and apply parking brake.
2. Refer to vehicle manufacturer’s recommended lifting points and position jack accordingly,
ensure that load is centered on saddle.
3. Rotate release valve clockwise until tight.
4. Lock handle position using one of the three position of the handle locator.
5. Attach air valve to suitable air source (90-175 psi). Depress air valve until saddle makes
contact with recommended lifting point, (ensure lifting point is aligned properly and safely).
Raise load to desired height.
6. WARNING: During lifting ensure load and jack are stable, if either appear to be unstable,
stop lifting, lower load and reposition jack.
7. IMMEDIATELY after reaching desired height, secure load with appropriately rated safety stands.
(refer to vehicle manufacturer’s recommended positioning)
LOWERING
1. Raise load high enough to remove safety stands.
2. WARNING: Ensure load does not shift or become unstable when lifting. If load is unstable,
slowly lower load back on to the safety stands. Correct instability and try again.
3. Carefully remove safety stands.
4. Lower load slowly.
!
MAINTENANCE
1. Depending upon usage, periodically add a few drops of air tool oil to air inlet.
2. Store unit in fully retracted position to avoid rusting of lift piston.
3. Grease the extension screw threads with a general purpose grease
4. Keep saddle area clean and free of grease or dirt.
