PART 1 • English
9
English
2. Connect the VCR SCART connector of the receiver to the SCART-IN connector on your VCR set.
Note
:
Please, make sure that your receiver is connected by SCART or 3 RCA cable (Video,
Audio L/R) to your TV set when you connect your VCR (or DVD) to receiver. You will not
get video signal from your VCR (DVD) through the receiver if your receiver is connected
only by HDMI or YPbPr connector to your TV set.
Fig. 3
3.3 Connecting to Digital Audio Amplifier
Connect S/PDIF connector at the back of your receiver to appropriated input of your Digital Audio Amplifier.
Fig. 3
3.4 Connecting to computer by serial cable
Connect the RS-232 connector on the back of your receiver to the Serial port of your computer using
a serial cable. Instructions how to download software can be found on our website www.strong.tv
(support > download). However, this receiver can download new system software from USB stick.
3.5 Connecting to external USB Hard disk
Switch on your external HDD (connect the power adapter if applicable) before you connect the USB
connector at the back of your receiver. After finishing the First Installation (Cap. 4.0) proceed with
following steps:
1. Unless the USB-Hard disk is already formatted in FAT32 and recognised successfully for the first
time you will get a message to format your device to FAT32 in “
Application
” > ”
USB
” menu.
2. In this menu press the
YELLOW
(Format) button on your remote control to confirm.
After ~10 to 20 sec. (depends on HDD size) formatting will be finished and you can leave the
menu with the
MENU
or
EXIT
button.
3. Go to “
Application
” >”
PDR
” menu to adjust the preferred recording duration and set
Timeshift to OFF or ON as desired.
4.0 STARTING UP FOR THE FIRST TIME
Ensure that your receiver is correctly connected to your television and terrestrial antenna. Make sure
terrestrial signals are of good quality. Ask your local STRONG dealer to check your terrestrial installation
or signal if you are not sure how to do this.
Confirm that the power plug of receiver is plugged into the wall outlet. Turn on the receiver by power
switch on rear panel. The language section menu will be showing on your TV Screen. It is recommended
that you do first time installation following Installation Wizard step by step. It will help you easily achieve
system configuration and channel installation.
