English
WARNING:
The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries. If rechargeable
accumulators instead of batteries are going to be used, we recommend
using (e.g. NiMH) types with low self-discharge to ensure long time
operation of remote control.
1.5 Usage of external USB devices
It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0
specifications, the playback with your receiver might not work properly.
If you are going to use external USB HDD (Hard Disk Drive) please consider that the power
specifications might exceed the supported output of your receiver (5 V/500 mA). If so, please
connect your USB HDD to an according external power adapter.
STRONG cannot guarantee compatibility with all types of USB storage devices.
It is advised not to store important information on USB storage devices used with the receiver.
Always make backups of data on your USB storage device before using it with this receiver.
STRONG will not take responsibility for any loss of information or circumstances caused by loss
of information.
Please ensure that either the USB device is already formatted to NTFS or FAT32 or format the
USB device via your receiver. Formatting requires entering the PIN code
STRONG cannot guarantee the playback of all files although extensions are listed, as it depends
on file size, codec, bit rate and resolution.
2.0 YOUR RECEIVER
2.1 Default PIN-CODE: 0000
You can change the PIN-Code in the main menu under
Channel List
then
Parental Lock
.
Make a note of your code.
2.2 Front Panel
Fig. 1
1.
LED 7-segment Display:
Displays channel number in operating mode or time in
standby.
2.
LED Mode indicator:
RED indicates that the receiver is in STAND-BY mode.
GREEN indicates that the receiver is in OPERATING
mode.
3.
IR sensor:
Point your remote control towards this sensor. (Hidden)
4.
USB:
Connector for USB devices.
2.3 Rear Panel
Fig. 2
1.
ANT IN
To connect to your antenna for the reception of broadcast signal.
2.
HDMI
To connect your receiver with your TV set using an HDMI cable.
3.
TV SCART
To connect your receiver with your TV set using a SCART cable.
5
