Strong SRT 6350 CI, User Manual

Page: 16 / 26

PART 1 • English
12
PCR PID: Use Numeric buttons to enter value of PCR PID in decimal
Press RED (Search) button to start channel search.
5.2.1.1 Positioner setup
If in Dish setup menu you have configured Dish mode as “DiSEqC 1.2” then you have to setup
position of the dish to each satellite that you want to install.
In
Channel setup menu move menu focus to Dish position item and press OK button on remote
control. Menu Positioner setup will appear on screen.
Satellite: Displays the name of satellite position of antenna for which you setup
T ransponder: Use
tu
buttons to select reference transponder, receivable in your location, to
measure signal strength and quality
Movement speed: Use
tu
buttons to select between Slow and Fast. Slow speed allows you to fine
adjust position of the dish. Fast speed can be used to adjust dish position roughly.
Move: Use
tu
buttons to move dish to the East/West direction
Centre position: If you press OK button while menu focus is on this item then dish will be turned to
centre position, which corresponds to true South direction.
Limits: Use
tu
buttons to Enable or Disable software limits of your positioner.
Set limit: Use
tu
buttons to select East or West limit of dish movement range.
Step by step recommendations of position setup.
1. Select reference transponder in order to check signal strength and quality during position setup.
2. If you do not know current direction of your dish then move menu focus to Centre
position item and press OK . Dish will be turned to true South. Knowing your location
longitude you may understand direction where necessary to move dish in order to reach
position of selected satellite. For example: your longitude is 5° East and you want to setup
dish position for Astra 1C, 1E (19° East). Then, from centre position, you need to move
dish to East direction by pressing to
t
button. If your longitude is 25° East then, in order
to setup dish position for Astra 1C, 1E (19° East), you need to move dish in West direction
(from centre position) by pressing to
u
button.
3. To setup roughly position of the dish set Movement speed to Fast. Then move menu focus
to Move item of the menu and by short presses to
t
or
u
buttons move dish to necessary
direction. Check signal strength and quality indicators. Once levels start increasing - set
Movement speed to Slow and keep adjusting dish position until get best possible values.
3. Once you are sure that dish is fine adjusted press YELLOW (Store) or BLUE (Store&Exit)
button. Dish position for selected satellite will be stored.
5.2.2 Dish set-up
In this menu you can setup parameters of your dish(es).
Dish number: Use
tu
buttons to select number of the dish. This number used in Channel setup
menu to create a link between satellite and corresponded dish configuration.
LNB type: Use
tu
buttons to select type of LNB. If you set type to “Customised” then you should
enter values of Local Oscillator Frequencies in LO frequencies menu item
LO frequencies: this menu item selectable only in case LNB type is “Customised”. Press OK button