PART 1 • English
11
English
Dish position:
this item value depends from the mode of the Dish.
if mode of selected dish is “Fixed” then this item is not selectable
if mode of selected dish is “DiSEqC 1.2” then value can be “Not stored” (in case dish position for
selected satellite was not stored”) or in range from 1 to 64 if position has been stored. Select item
and press OK to setup positioner. More details about Positioner setup read in chapter 5.2.1.1.
if mode of selected dish is “GOTO X” then value is “GOTO X”. Select item and press OK to setup
GOTO X function. More details read in chapter 5.2.4.
Transponder:
move focus of the menu to this item and press
OK
. List of transponders of selected
satellite will appear at right side of the screen. You can select transponder in order to check signal
strength and quality of reception. Transponder list contains predefined transponders. If you need to
modify transponder list please use menu
“Edit satellites”
as described in chapter 5.2.3. If you need
to scan specific transponder then use Manual scan as described in this chapter below.
Network search:
if this item is set to
“OFF”
then receiver will search for the channels that are
available from preset transponder list of selected satellite. If this item is set to
“ON”
then receiver in
addition will search for the channels from transponders information about that can be found from
broadcast. Use this option to get new channels that appeared on satellite.
Search for:
you can select type of the channels that will be installed to your receiver.
if selected
“All channels”
then receiver will install Free-To-Air and Scrambled channels
if selected
“Scrambled”
then receiver will install only Scrambled channels
if selected
“FTA”
then receiver will install only Free-To-Air channels
Once you complete all settings you can start channel search process.
Press
RED
button to setup channels from all transponders of the satellite;
Press
GREEN
button to setup channels from transponder selected in Transponder item;
Press
YELLOW
button to enter to Manual setup channels from specific transponder or to setup
single channel with known Video and Audio PIDs.
Manual setup of channels
In Manual channel search menu you can setup all channels from specific transponder or single channel.
To setup all channels from specific transponder:
Satellite:
indicate name of the satellite where channels will be searched
Frequency:
Use
Numeric
buttons to enter frequency of transponder
Polarisation control:
Use
tu
buttons to select polarisation of transponder
Symbol rate:
Use
Numeric
buttons to enter symbol rate value
Network search:
Use
tu
buttons to select ON or OFF
Search for:
Use
tu
buttons to select type of channels to be installed
Press
RED
(Search) button to start channel search.
To setup single channel:
Press
GREEN
(PID) button on the remote control.
Satellite:
indicate name of the satellite where channels will be searched
Frequency:
Use
Numeric
buttons to enter frequency of transponder
Polarisation control:
Use
tu
buttons to select polarisation of transponder
Symbol rate: Use
Numeric
buttons to enter symbol rate value
Video PID:
Use
Numeric
buttons to enter value of Video PID in decimal
Audio PID:
Use
Numeric
buttons to enter value of Audio PID in decimal
Summary of Contents for SRT 6350 CI
