46
English
45
Troubleshooting
There may be various reasons for the abnormal operation of the unit. Therefore, if the unit
does not work properly, check it according to the procedures shown in the table below:
6.8 DVR
5) Timer Recording
This feature is available when a USB device is connected. You may choose a channel to
record using the EPG (see section 6.4)
6) Time Shift
⊹
To pause and resume live TV press PAUSE. The default time shift is 30 minutes <Fig
6.8.12>
⊺
To resume live TV press PLAY <Fig 6.8.13>
͊
To jump to a live channel press
<Figure 6.8.12>
<Figure 6.8.13>
4) Recording Stop
⊹
Press
on the remote to stop the recording and “Record Stop” will be displayed.
⊺
Select the recording file using
/
⊻
Press EXIT to stop the selected recording.
<Figure 6.8.11>
Remedy
Connect the power cord properly
into the power socket.
Connect the two terminals
correctly with RCA or RF cable(s),
HDMI cable(s).
Connect the antenna cable
correctly.
Adjust the direction of the
antenna.
Check the cable connections
Type the setting values correctly.
Use a TV of the same mode.
Connect a NTSC/PAL converter
between the receiver and the TV.
Change the batteries.
Switch off the light.
Aim the remote control at the
receiver.
Check mains supply and ensure
that the unit is witched on both at
the mains and at the power
switch on the rear of the receiver.
Possible causes
The AC power cord is
disconnected.
Wrong connection of the
video/audio output to the
TV input terminal.
Wrong connection of the
terrestrial cable.
No signal or weak signal.
Wrong setting of channel
information in the MENU
screen.
Your TV mode (PAL/NTSC)
is different from the
terrestrial broadcasting
mode.
Batteries are exhausted.
Fluorescent light is
interfering with the remote
controller.
Remote controller is
incorrectly aimed.
No Power or Switched off.
Problem
The LED light on the front
panel does not light.
No Picture or sound.
Black-and-white
screen or V-Hold.
The remote controller is
not working.
Unit will not operate.
