PART 1 • English
16
Symptom
Remedy
Audio & video issues
TV Picture changes
colour
This may happen after a power-cut or disconnection from the power source.
Your receiver has lost some software settings. Switch off your receiver and
on again after a few seconds. If the problem persists, contact your vendor.
Blocks in the TV picture
The signal is too weak or defective due to e.g. bad weather conditions. Try to
adjust your aerial position or wait for the signal to be re-established.
A.2 SPECIFICATIONS
Demodulator
Demodulator:
COFDM; 16 QAM/64 QAM
Transmission mode:
2 K ~ 8 K
Video Decoder
Profile level:
MPEG-2 MP@ML
Video resolution:
720 x 576 pixels (PAL), 720 x 480 (NTSC)
Decoding & Video Out:
PAL & NTSC
Aspect ratio:
4:3, 4:3 FULL, 16:9
Audio Decoder
MPEG MusiCam Layer I & II
Sampling rate:
32, 44.1, 48 kHz
Audio mode:
Stereo, Joint Stereo, Dual Mono
Tuner
Front End:
DVB-T, UHF & VHF Tuner
Input frequency range:
174 ~ 470 MHz (VHF) and 470 ~ 862 MHz (UHF)
Loop through frequency range:
47~862 MHz
Input signal level:
-82 ~-20 dBm
Memory and System
Flash memory:
2 x 1 MByte
SDRAM:
8 MByte
Summary of Contents for SRT 5220
Page 1: ...Digital Terrestrial Twin Tuner Receiver SRT 5220 User Manual Picture similar ...
Page 2: ......
Page 3: ......
