13
English
12
6.1 Getting Started
(When the DiSEqC Motor parameter is set as 1.2 <Figure 6.1.4>)
- Satellite
: Select any satellite by pressing
/
buttons.
- Frequency
: Displays the current TP value of the selected satellite.
- Move
: Move the dish position to west/east by pressing
/
buttons.
- Move Fine
: Move the dish position 1 step at a time to west/east by pressing
/
buttons.
- Motor Control
: Control motor by press
button on the remote. <Figure 6.1.5>
ҥ
Recalcuate
: Recalculate the position of all other saved satellites relative to the
known position.
ҥ
Reset System
: Reset the position of all saved satellites.
ҥ
Goto Reference
: Move the dish to the 0 position.
ҥ
Disable Limit
: Disable east and west limit.
ҥ
Enable Limit
: Enable the saved east and west limit.
ҥ
Set East Limit
: Edit & Save east limit by pressing
/
or
buttons.
ҥ
Set West Limit
: Edit & Save limit by pressing
/
or
buttons.
- Go To
: Go to the position of the saved satellite.
- Save
: Save the current setting of DiSEqC 1.2 system.
<Figure 6.1.4>
<Figure 6.1.5>
6.1 Getting Started
͋
Select the item that you want to edit, and set its parameters as desired. <Dish Setting>
- Frequency :
If the default TP frequency is not appropriate, you can select another TP
frequency at which to check for signal.
- LNB Power :
Select among ON/OFF/13V/18V.
- LNB Type :
Select among Single/Universal/OCS.
- LNB Freq :
Set the frequency of the LNB oscillator.
- 22KHz :
When not AUTO, set the signal path from LNB or switch by selecting a control
signal among 0/22KHz.
- DiSEqC 1.0
: Select DiSEqC 1.0 Port
- DiSEqC 1.1
: Select DiSEqC 1.1 Port
͌
Select the item that you want to edit and set its parameters as desired. <Motorized
Setting>
- DiSEqC Motor :
Select DiSEqC protocol among OFF/1.2/USALS as appropriate for
your Motor.
<Figure 6.1.2>
<Figure 6.1.3>
2) Antenna Setup
͈
Press the
MENU
button to display the main menu.
͉
Use
/
and /
to move in the menu.
͊
Press
on ‘Dish Setting’. The following window will appear. <Figure 6.1.2>
If you have a motorized dish, press
on ‘Motorized Setting’. < Figure 6.1.3>
ҫ
Note : Enter a 4-Digit password if need arise. The default password is ‘0000’.
