-4-
T-C-CCN64AU17 © 2017 Simpson Strong-T
ie Company Inc.
BEFORE HANDLING OR OPERATING THIS TOOL READ AND
UNDERSTAND THE WARNINGS IN THIS MANUAL.
SAFETY INSTRUCTIONS
EYE PROTECTION
that
conforms to AS/
NZ
specifications and
provides protection
against flying debris from front and
sides shall always be worn by the
operator and others in the work area.
The employer and/or operator are
responsible to ensure proper eye
protection is worn. Non-side-shielded
eye protection and face shields do
not provide adequate protection.
HEARING PROTECTION
that conforms to AS/
NZ specifications may
be required in some
environments that include exposure to
noise that could affect hearing damage.
HEAD and FOOT
PROTECTION
that conforms
to AS/NZ
specifications may be required in some
work environments with head and
foot hazards. Dress appropriately.
WARNING
• Know and understand
the trigger system.
• Operate the tool
only on the workpiece and at
90 degrees to the workpiece.
• Never assume the tool is empty.
• Never engage in horseplay
with the tool.
• Carry the tool by the handle.
Do not lift by hose.
• Never leave the tool unattended
with the air supply connected.
• Do not use the tool as a hammer.
• Do not continue to use the tool if it
leaks air or fails to function properly.
• Use clean, dry, regulated
compressed air.
• Do not use the tool while tired,
after having consumed drugs
or alcohol, or while under the
influence of medication.
• Do not over reach. Keep proper
footing and balance at all times.
LOADING AND
UNLOADING THE TOOL
• Use only nails
recommended by Simpson
Strong-Tie for use in the CCN64 tool.
•
Disconnect air supply before
loading and unloading.
•
Always handle the tool with care.
•
Never point the tool at yourself
or another person.
•
Do not depress the nose of the
tool or it will activate driving.
