24
Quasar Owner's Manual
Strong Enterprises
ATTACHING THE PILOT CHUTE AND DEPLOYMENT BAG
NOTE: If your canopy does not have a metal ring but simply a loop made of nylon webbing,
then the use of a rapid link is necessary for attachment. DO NOT tie the bridle
directly to the canopy without a ring or rapid link. This will cause canopy fabric to be
pulled through the bag’s grommet upon deployment causing canopy damage.
ATTACHMENT OF OPTIONAL COLLAPSIBLE PILOT CHUTE
If you ordered your new Quasar with the optional collapsible pilot chute, follow these
instructions for its assembly. Please reference the assembly drawing on page 28.
1. Insert the bridle loop through the bag grommet.
1. To attach, pass the loop at the end of the pilot chute bridle through the bag’s grommet. The
loop should extend out of the grommet on the inside of the bag.
2. Now pass the loop through the metal ring, which is sewn to the top of your canopy, and
then pass the entire pilot chute and deployment bag back through the loop and pull tight.
2. Secure the loop by placing the supplied #4 rapid link through the bridle loop and the 1”
Type IV loop sewn inside the bag.
3. Tighten the link and turn it so that the nut is hidden inside the Type IV loop.
Note: The bridle should be attached to the bag so that the deflation line and the D-ring are on
the opposite side from the Type IV loop.
4. Route the continuous deflation line straight through the grommet.
5. Route the finger trapped Y-line out through the D-ring and then down through the
grommet.
6. Secure both lines to the top of the canopy with the other supplied #4 rapid link.
Summary of Contents for STELLAR RESERVE Quasar
Page 1: ......
