Strobel 560-11, Operating Instructions Manual, Page: 11 / 32

7
BA_560_A4_180619_en
3
3.1
Installation and putting into service
The machines of series 560-11 and -21 are supplied as complete units with
stands only.
Unpacking the machine
The Reel stand and another machine accessories located into the packaging.
Make sure that all accessories have been unpacked before throwing away any
packing material.
3.2 Installation (Fig. 1)
A T T E N T I O N !
Danger of bodily injuries or finger bruises through pulling in
of garments or hairs!
The machine may not be operated without belt guards
for head and motor.
The electrical connection must be carried out according to the marking of the
cable or the supplied wiring diagram.
Check if all screws on the stand are tight and retighten them, if necessary.
Before putting the machine into service make sure that the electrical connecting
data on the motor's name plate, your electric network and the frequency, and all
other connecting values, e.g. for the air, correspond to the data shown on the
machine and the operating instructions.
Since feed cup opening and some other operations are realized pneumatically,
a compressed air connection of 6 bar is required (see point “2.4 Technical
Data”). Regulation of the pressure by means of compressed air conditioner.
A T T E N T I O N !
Before putting the machine into service make sure
that the electrical connecting data on the motor’s
name plate, your electric network, and all other
connecting values, e. g. for the air correspond to
the data shown on the machine and the operating
instructions.
All rust preventing agents, such as Vaseline and similar agents, have to be
wiped off carefully, particularly from the most important sewing tools.