Stricker CITY 7, Instructions Manual

Page: 7 / 36

Manual English V16/04 page 7
5 Attach your Hand-Bike to the wheelchair
(There is also an Video CD available vor adjusting the handbike)
After the Hand-Bike is adjusted to the rider and to the wheelchair (see chapter 7) it can be
attached to the wheelchair.

Open the clamps wide enough to push them over the front frame tubes of the
wheelchair. Do not open too wide; otherwise, the bolts may come off.

Loosen the spanner levers H2L and H2R (picture 6), to enable the spanner to move
in the slot hole. Turn the clamps in such a way, that the spanners are approximately
in the middle of the slot hole.
Picture 3 picture 3a

Hold the Hand-Bike on the handle and attach it to the front of the wheelchair frame.
Then close the clamps (picture 6) on both sides.
CAUTION : Tighten the clamps with max. 6-8 Nm!
Hint1: To make the attachment even easier fix the handbrake on the front
wheel. This avoids uncontrolled movements of the Hand-Bike. By also
fixing the handbrakes on the wheelchair, you have both hands free to attach
the Hand-Bike.
Hint2: Attaching the Hand-Bike to the wheelchair is even easier with the
position-clamp (optional), which is attached to the wheelchair. Simply put
the Hand-Bike on top and fix the clamps.

Push the handle forward to lift the front wheels of the wheelchair, and then fix the
levers H2L and H2R (picture 6).
Attention:
The handle needs to be pushed, until the levers are in the front end of the slot
hole (above the recess, picture 4). Keep pushing the handle with one hand,
while you fix the levers with the other hand.
handle