EXPLANATION OF SYMBOLS:
Read the instructions for use.
Wear protective gloves.
Do not dispose of as normal household waste. Instead, contact your recycling center in an
environmentally friendly way. Please take care of environmental protection.
Double insulation protection II. Grounding is not required.
The product complies with the applicable European directives and the conformity assessment
method of these directives has been implemented.
GENERAL SAFETY INSTRUCTIONS
- WARNING!
Make sure that you read the safety instructions, labels and technical data provided with this
electric tool.
Failure to do this may result in the risk of electric shock, fire and/or serious injury.
1) OPERATIONAL SAFETY:
- The workplace shall be clean and properly illuminated. Accidents are likely to happen in dark and messy
places.
- Do not use the electric tool in areas with the risk of explosion or the presence of flammable liquids, gases
or dust. The electric device might generate sparks that could ignite the dust or fumes.
- When using the electric tool, keep the children and other people out of the area. If you will be disturbed,
you might lose control over the device.
2) ELECTRICAL SAFETY
- Pins of the electric plug shall be compatible with the socket. Never modify the electric cable by any means.
If the plug of the tool has the earth pin, never connect it through a two-way adaptor or other adaptors.
Undamaged plugs and sockets lower the risk of electric shock. Damaged or tangled cables increase the risk
of electric shock. If the cable is damaged, it shall be replaced with similar cable that can be obtained from
the manufacturer or their sales representative.
- Body of the operator shall not touch grounded objects like pipeline, central heating device, cookers or
fridges. If your body is connected to the ground, the risk of electric shock is higher.
- Keep the electric tool away from rain, humidity or water. Never touch the electric tool with wet hands.
Never wash the electric tool in running tap water and never dip it into water.
- The cable shall not be overstretched. Never unplug the electric tool by pulling out the cable. Keep the cable
away from warm objects, oil, sharp edges or moving parts. Damaged or tangled cables increase the risk of
electric shock.
- Never work with the tool with damaged cable or plug, or if it has fallen to the ground and was damaged.
- When using the tool outside, use the extension cable suitable for external use. Doing so lowers the risk of
electric shock.
- If you use the electric tool in wet areas, please use the power supply protected by residual-current device.
Residual-current device decreases the risk of electric shock. Term “residual-current device” has an equivalent
term “ground fault circuit interrupter” or “earth leakage circuit breaker”.
- Hold the electric tool by the insulated areas intended for that, since the tool might meet with cutting or
drilling tools with hidden conductor or own cable.
3) PERSONAL SAFETY
- Please be careful when using the electric tool, pay the maximum attention to your work. Concentrate on
the work. Do not work with the electric tool when tired or when you are under the influence of drugs, alcohol
or medicine. People can get seriously injured even during momentary inattention when using the electric
tool. Do not eat, drink or smoke when operating the el. device.
- Use the protective equipment. Always wear the eye protection. Use the corresponding personal protective