EN
pin on the lid will fasten in the position buckle (figure 4), after the installation of the coupler it will looks as
showed in the figure. Before you shut on the appliance make sure that the selector switch and the thermostat
are switched off. And the arrow on selector switch and thermostat are to be in OFF position. If the switch
and thermostat are not in Off position, put them to off, so that when you connect the plug with power supply,
there will be no sparkle induced between the plug and the socket outlet, which can extend the work life of
the plug. Then connect the plug to the power, operate the appliance. During the operation if sparkle was
detected at connection part, shut down the appliance, pull put plug and connect again.
4) After use shut down the appliance firstly, pull out the plug, then put off the position pin and remove the
coupler.
Cleaning and maintenance
Before cleaning the appliance, disconnect it from the socket and let it cool down.
The enclosure is easily to get dirty, wipe it often with soft sponge. For very dirty parts, wipe with a sponge
dipped in < 50
℃
water and mild detergent, then dry the heater enclosure with clean cloth. Be careful not to
let the water enter the appliance inner.
Don’t splash water onto the heater, never use solvent like gasoline, isoamyl acetate, toluene etc. to clean the
heater, in order to protect the enclosure.
Clean the coupler, dry and pack it in a plastic bag.
When you store the heater, let it cool down first, keep it dry. Then cover it with a plastic bag, put in the
packing box and store it in a dry, ventilated place.
