EN
CONTROL PANEL
switch knob
thermostat knob
OPERATION
- The heater is supplied with industrial socket installed in the heater.
- You must purchase a suitable additional coupler to connect to a power source.
1 – Five pins connector 380 V / 50 Hz
2 – Power cord
3 – Five pins plug 380 V / 50 Hz IPX4
- The coupler should be VDE approved.
- The length of the power cord can be more than 1.8 m but less than 3 m, if the power cord is too long and heavy,
it can be disconnected from the connector or plug, or someone may trip over it and cause an electric shock.
- When connecting the coupler to the device, be careful of the correct wiring direction.
- After use, switch off the appliance, unplug it and then unplug the coupler.
OPERATING MODES
switched off
with only the fan operating
fan and one heating element are operating (4500 W)
fan and two heating elements are operating (max. 9000 W)
